Front Suspension

Remove all screws and nuts and remove th…
If so, you have to remove the complete a…
Notice the extend of wear as you can mov…
I wouldn't recommend you to use MOOG bal…
This is the new one where the pin is roc…
TRW brand stamped on the bottom of the b…
Install the new ball joint in place with…
Fully tighten the nut ball joint to hub.
Get hold of spring compressors. This is …
Install spring compressors and tighten t…
Rubber dust boot has split. 
Strut pan bearing doesn't look too bad a…
Use a 6 mm key to lock strut rod while u…
In fact the pan bearing has collapsed.
The spring plate shows quite some rust.
New and used parts demonstrated.