Brake Pads
Brake Pads
April 29, 2020
32
This article describes the process of replacing the front brake pads. The brake warning check light comes on when the brake pads have reached the end of their service life and it is a really easy job to do for the DIY enthusiast.
Required parts
- Brake pads set
- Wrenches 13mm & 15 mm
- Small piece of wood block
- Caliper tool
- Moly grease (CV joints grease)
Remove the worn brak…
Remove the pins from…
Clean the pin and ap…
CV joints grease is …
Just enough grease t…
Grease properly appl…
The brake piston ext…
A small piece of woo…
The brake caliper pi…
Install new brake pa…
Pass the brake pads …
New screws fixing ca…
Make sure to fully b…
Do the same for the …
Pass the sensor thro…
Connect the brake pa…